NOTE: Before starting the process, make sure that HP Coated Paper is loaded and ready to print.
At the end of the process, the printer checks whether the current calibration values are valid, using the
data obtained during the paper advances. If the values are considered valid, then the following
message will be shown.
If they are not valid, the front panel displays the reason (for example, the AMP1 parameter value is
greater than the maximum allowed).
Press OK to return to the main screen.
Perform new calibration
This option performs a calibration in order to obtain a new set of calibration values. The printer makes
a series of paper advances, and the OMAS sensor registers the distance covered in each advance.
When all the paper advances have been performed, the calibration values are calculated based on the
data obtained.
NOTE: Before starting the process, make sure that HP Coated Paper is loaded and ready to print.
1. The printer checks that there is paper ready to print. If there is no paper ready, the following
message is displayed. After a few seconds, the front panel automatically returns to the Paper
Advance Calibration submenu.
2. If there is paper ready, the printer performs the zero search for the Paper Motor. During this
phase, the following message is displayed.
3. When the Paper Motor has been initialized, the printer starts to perform the series of paper
advances. During this process, the front panel displays the current iteration number and the total
number of iterations.
You can cancel the calibration process at any time by pressing Cancel. In this case, the previous
calibration values are restored and the cancelled process has no effect on the printer.
ENWW
Entering the Service Calibrations menu
125
To Next Page
Loading...