2 Troubleshooting
●
Printer education and training
●
Firmware update
●
Print-quality troubleshooting
●
Troubleshooting system error codes
●
Performing a service test on a failed assembly
●
Performing the necessary service calibrations
●
The printer does not power on
●
The printer hangs during printing and displays ‘processing’
●
The printer continuously rejects printheads
●
A new maintenance cartridge is incorrectly detected as ‘used’
●
Cover sensors are not working
●
The Line Sensor has problems detecting paper
●
How to remove the Left Hub when the actuator is broken
●
Troubleshooting paper jams and printhead crashes
●
Troubleshooting shutdowns
●
Vacuum suction much lower at high altitudes
●
Banding at variable extreme environmental conditions
●
Printhead crashes/smears on high-density prints using coated paper
●
Banding due to ink cartridge replacement while printing
●
34" Rice Paper not supported
●
Worm marks on HP Coated Paper with light area fills
●
Solving paper-handling problems
●
Difficult to load paper: “Too much skew”
●
How to read the power switch LEDs
●
How to read the Formatter LEDs
ENWW 5
To Next Page
Loading...