OMAS Calibration
The purpose of this Service Calibration is to calibrate the OMAS Module. The calibration process
consists of printing a special calibration plot and then scanning it with the printer. The resulting scanned
values are compared with the actual printed values to obtain a PASS/FAIL result.
NOTE: In order to perform this calibration, you should order the Paper Advance Calibration Kit (part
number CQ109-67042), which contains a 150-ft roll of HP Coated Paper, 36 inches wide (part
number C6020B).
Print OMAS Calibration Pattern
1. Load the roll of HP Coated Paper from the Paper Advance Calibration Kit into the printer.
2. In the Service Calibrations menu, scroll to OMAS Calibration and press OK.
3. In the OMAS Calibration submenu, scroll to Print Calibration Pattern and press OK.
4. When the following message appears on the front panel, press OK to continue with the
calibration, or press Cancel to exit.
5. The printer starts to print the OMAS Calibration Pattern. This could take several minutes, during
which the following message is displayed on the front panel.
140 Chapter 6 Service calibrations ENWW
To Next Page
Loading...