6. Once the OMAS Calibration Pattern has been printed successfully, the following message is
displayed on the front panel. Press OK to continue.
If the OMAS Calibration Pattern fails to print for any reason, an error message is displayed with
instructions to follow. Try the process again, making sure to select HP Coated when loading the
36-inch roll that is provided. If the Calibration Pattern still fails to print, unload all rolls, restart the
printer and try again.
NOTE: Remove the Calibration Pattern from the printer and leave it to dry for a few minutes
before continuing with the calibration.
Scan OMAS Calibration Pattern
1. Re-enter the OMAS Calibration submenu, scroll to Scan Calibration Pattern and press OK.
2. When the following message appears on the front panel, press OK to continue with the
calibration, or press Cancel to exit.
3. You must remove all rolls of paper from the printer. Follow the instructions on the front panel to
remove the rolls.
4. The front panel advises you to prepare the OMAS Calibration Pattern for loading into the printer.
Rotate the printed pattern 90° clockwise, with the printed side down. Press the OK key when you
are ready to load.
5. The front panel prompts you to load the OMAS Calibration Pattern into the printer.
ENWW
Entering the Service Calibrations menu
141
To Next Page
Loading...