Example defective advance plot
This defect has the follow possible causes:
●
OMAS is not clean or is defective so you should repeat the plot with OMAS disabled. This will
allow you to establish if this is an OMAS related fault. If the same fault is detected the problem
cannot be attributed to OMAS.
●
The Drive roller is not clean so it slips against the media.
●
Any other component affecting the media advance:
◦
Spindle/Back Tension
◦
Input roller
◦
Pinchwheels
Example defective nozzle plot
This example is caused by a defective nozzle so there is no issue with the paper advance.
ENWW
How to use the Image Quality Service Diagnostic Print
167
To Next Page
Loading...