To cap the Printheads:
●
The Carriage Assembly is first positioned over the Service Station.
●
The Maintenance Cartridge moves towards the back of the printer which allows Pin #1 and Pin #2
on the Carriage Assembly to push against Rib #1 and Rib #2 to lift the caps into contact with the
Printheads.
Improper capping of printheads will occur when any of the following elements break:
●
Rib #1 or Rib #2 of the Maintenance Cartridge,
●
Pin #1 or Pin #2 of the Carriage Assembly
You should also check all the other elements of the Maintenance Cartridge (plastic of each cap, and so
on) and make sure the vacuum ports are clear. If they are blocked, you can clear them with a T-8 Torx
bit but you should also check to make sure the Aerosol Fan is operating correctly.
Working with other commercially available papers
This section provides a quick reference guide to selecting the correct settings in the printer so that the
printer acheives the best possible image quality when using a paper type that does not come from HP.
For papers available in the market from sources other than HP, please refer to the information in Tables
1, 2 and 3 in order to choose the correct category.
Table 1 defines the print characteristics used in Tables 2 and 3.
ENWW
Working with other commercially available papers
181
To Next Page
Loading...