7. Unclip the cables from the cable clamps.
8. Unroute the Vacuum Fan Cable from the Interconnect PCA.
Installation
Make sure that the OMAS ribbon cable is free of slack when you install the cable clamp.
After installing the new Vacuum Fan, make sure you perform Paper-advance Calibration
Paper-
advance calibration on page 124.
Aerosol Fan and Filter
Removal
WARNING! Switch off the printer and remove the power cable.
1. Remove the Right Cover See Cover, Right on page 224.
2. Remove the PW Cover
See PW Cover on page 343.
3. Remove the Right Connector Cover
See Connector Cover, Right on page 236.
4. Remove the Service Station
See Service Station on page 244.
ENWW
Disassembly order
253
To Next Page
Loading...