5. Remove four T-15 screws (Type G) that secure the Aerosol Fan to the Service Station.
6. Remove the Aerosol Fan from the Service Station.
7. If necessary, remove the Aerosol Fan Filter from the Aerosol Fan.
Installing
When the new aerosol Fan and Filter have been installed, it is important to check that the fan is
funcioning correctly, otherwise the printer will suffer from Aerosol spray. To check that the fan is
working correctly, make sure the printer is printing and check for airflow in the area of the rear of the
Service Station.
254 Chapter 9 Printer part removal and installation ENWW
To Next Page
Loading...