7. Push inwards the four clips that secure the Carriage PCA.
8. Remove the Carriage PCA from the printer.
NOTE: Once you have installed a new Carriage PCA, you must perform the following steps to ensure
that the printer will function correctly:
1. Turn on the printer.
2. Install the Printheads.
3. Reset life counter Carriage PCA
Reset Life Counters on page 112.
Carriage Flex Cables
Removal
WARNING! Switch off the printer and remove the power cable.
1. Remove the Right Cover See Cover, Right on page 224.
2. Remove the Front Panel
See Front Panel on page 237.
3. Disconnect the Trailing Cable from the Carriage PCA.
292 Chapter 9 Printer part removal and installation ENWW
To Next Page
Loading...