NOTE: To simplify the installation of the OMAS an Attachment Screw Retainer has been added to
hold the two T-20 attachment screws. This part is delivered attached to the replacement OMAS unit
with the two attachment screws. It is also delivered as a separate part with the Center Platen in case the
OMAS is completely removed during its replacement.
1. Check that the two T-20 attachment screws are correctly positioned in the Attachment Screw
Retainer.
2. Position the OMAS under the printer and connect the large ribbon.
3. Lock the clips of the large ribbon cable connector.
356 Chapter 9 Printer part removal and installation ENWW
To Next Page
Loading...