8. Remove two T-20 screws (Type M) from each Pinchwheel Subassembly (a 90° screwdriver is
included with the replacement Pinchwheel Assembly).
9. Remove the complete Pinchwheel Assembly (including the Cam and Cam Lever) from the printer.
NOTE: Before installing the new Pinchwheel Assembly, insert the plastic studs into each
Pinchwheel subassembly. This will make it easier to install the complete Pinchwheel Assembly.
Removing individual Pinchwheel Rollers
406 Chapter 9 Printer part removal and installation ENWW
To Next Page
Loading...