Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Check that the Trailing Cable is not damaged.
●
Check that the Trailing Cable is correctly connected to the Carriage PCA, Interconnect PCA and
Main PCA.
●
Replace the Carriage PCA
Carriage PCA on page 290.
SE 03:10
Cause: Power distribution failure
Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
If the Power Supply Unit's blue LED is on, replace the PrintMech PCA
PrintMech PCA
on page 384. If not, replace the Power Supply Unit Power Supply Unit (PSU) on page 379.
SE 05:10
Cause: Formatter communication failure with ISS
Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Check that the Formatter to PrintMech PCA cable is correctly connected.
●
If the printer is a Rev A, replace the Formatter
Formatter on page 373.
●
If the printer is a Rev B, replace the Formatter and the Hard Disk Drive
Hard Disk Drive (HDD)
on page 376.
SE 05.1:10
Cause: Formatter CPU fan stopped or burnt
Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
If the printer is a Rev A, replace the Formatter
Formatter on page 373.
●
If the printer is a Rev B, replace the Formatter and the Hard Disk Drive
Hard Disk Drive (HDD)
on page 376.
SE 06:03
Cause: Main NVM communication failure
ENWW
Continuable and non-continuable error codes
47
To Next Page
Loading...