Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
If the printer is a Rev A, replace the Hard Disk Drive
Hard Disk Drive (HDD) on page 376.
●
If the printer is a Rev B, replace the Hard Disk Drive and the Formatter
Formatter
on page 373.
SE 06:10
Cause: Main NVM communication failure
Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
If the printer is a Rev A, replace the Hard Disk Drive
Hard Disk Drive (HDD) on page 376.
●
If the printer is a Rev B, replace the Hard Disk Drive and the Formatter
Formatter
on page 373.
SE 08:11
Cause: Front Panel communication failure
Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
See
What to do if the front panel is blank on page 42.
SE 11:10
Cause: Trailing Cable does not seem to be connected
Solution: Try the following.
●
Check that the Trailing Cable is not damaged.
●
Check that the Trailing Cable is correctly connected to the Carriage PCA, Interconnect PCA and
Main PCA.
●
Replace the Ink Supply Tubes and Trailing Cable.
NOTE: If the Ink Supply Tubes are to be replaced, the Ink Cartridges need to be checked
beforehand to see if they are capable of purging the new tubes. If they are not, new Ink
Cartridges must also be sent with the parts to be replaced. To check the Ink Cartridges, see
Check
ink supplies on page 98.
SE 17.0:11
Cause: PrintMech to Interconnect Power cable does not seem to be connected
48 Chapter 3 System error codes ENWW
To Next Page
Loading...