SE 29:01
Cause: Maintenance Cartridge not inserted correctly
Solution: Try the following.
●
Open the Maintenance Cartridge door on the right-hand side of the printer, make sure that the
maintenance cartridge is correctly seated, then close the door.
●
If the problem persists, replace the Maintenance Cartridge.
SE 29:02
Cause: Ink Absorber almost full
Solution: Replace the Ink Absorber.
SE 35:10
Cause: Rear Door sensor error detected
Solution: Try the following:
●
Check that the Left and Right Rear Door Sensor cables are not damaged and are connected
correctly to the Interconnect PCA.
●
Replace the Rear Door
Rear Door on page 345.
SE 37:03
Cause: ARSS motor shutdown
Solution: Try the following:
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Replace the Rear Door
Rear Door on page 345.
SE 38:03
Cause: Stacker communication protocol error
Solution: Try the following:
●
Restart the printer.
●
Check that the cable between the stacker and the printer is undamaged and correctly connected.
●
Update the stacker firmware.
●
Replace the Stacker Electronics PCA
Electronics PCA on page 444.
SE 38.0:01
Cause: Paper jam detected in stacker; buffer sensor activated
58 Chapter 3 System error codes ENWW
To Next Page
Loading...