SE 38.4:10
Cause: Stacker heating element failure
Solution: Try the following:
●
Turn the power off from the rear of the printer and disconnect the power cord. Reconnect the
power cord and turn on the printer.
●
Check that the Heating Lamp is correctly installed.
●
Replace the Heating Lamp
Heating Lamp on page 451.
SE 38.5:01
Cause: Stacker motor overload
Solution: Try the following:
●
Check that the Drive Motor is not blocked by turning the stacker off and on.
●
Check that the Stacker Transport Belt can turn freely.
●
Check for any debris in the paper path.
●
Check that all the connections to the Drive Motor are correct.
●
Replace the Drive Motor
Drive Motor on page 428.
SE 38.5:10
Cause: Stacker abnormal motor condition
Solution: Try the following:
●
Check that all the connections to the Drive Motor are correct.
●
Replace the Drive Motor
Drive Motor on page 428.
SE 38.5:11
Cause: Stacker motor encoder failure
Solution: Try the following:
●
Check that all the connections to the Drive Motor are correct, especially the connection to the
encoder.
●
Replace the Drive Motor
Drive Motor on page 428.
SE 38.6:11
Cause: Stacker power supply failure
Solution: Try the following:
●
Replace the Stacker Power Supply Unit
Power Supply Unit on page 447.
ENWW
Continuable and non-continuable error codes
61
To Next Page
Loading...