SE 52:10
Cause: Drop Detector switch On/Off failure
Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Check that the Drop Detector cable is not damaged and is correctly connected to the Service
Station cable.
●
Check that the Service Station cable is not damaged and is correctly connected to the Interconnect
PCA.
●
Replace the Drop Detector
Drop Detector on page 255.
SE 53:10
Cause: Media Sensor error
Solution: Try the following.
●
Check that the Media Sensor cable is not damaged and is connected correctly to the Interconnect
PCA.
●
Replace the Media Sensor
Media Sensor on page 337.
SE 53.1:11
Cause: Media Sensor cable does not seem to be connected
Solution: Try the following.
●
Check that the Media Sensor cable is not damaged.
●
Check that the Media Sensor cable is correctly connected to the Interconnect PCA.
SE 55:10
Cause: Line Sensor communication failure
Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Replace the Line Sensor
Line Sensor Assembly on page 298.
SE 56:01
Cause: Incorrect readings from paper encoder
68 Chapter 3 System error codes ENWW
To Next Page
Loading...