Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Perform Paper Drive diagnostics.
●
Replace the Encoder Disc and Sensor
Encoder Disc and Sensor on page 400.
SE 56:10
Cause: Paper Encoder calibration failed
Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Perform Paper Drive diagnostics.
●
Replace the Encoder Disc and Sensor
Encoder Disc and Sensor on page 400.
SE 59.1:09
Cause: Two electrical parts have been replaced at the same time
Solution: Replace one part at a time, and restart the printer before replacing another.
SE 59.2:00
Cause: An unsupported or reused part has been installed
Solution: Install only new parts recommended by HP for this printer.
SE 60.1:11
Cause: Initialization error
Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord.
●
Check that the printer is properly connected in all other respects. In particular, check that the tag
cable is well connected to the ISS Top PCA, and the ISS Top PCA is well connected to the
PrintMech PCA.
●
Reconnect the power cord and turn on the printer.
●
If the error persists, contact HP.
SE 60.2:17
Cause: Initialization error
Solution: Contact HP.
ENWW
Continuable and non-continuable error codes
69
To Next Page
Loading...