SE 61:01
Cause: The file format is incorrect and the printer cannot process the job
Solution: Try the following.
●
Turn off the printer using the switch at the rear, and disconnect the power cord. Reconnect the
power cord and turn on the printer.
●
Check the graphic language setting of the printer (see the User’s Guide).
SE 61:04.1
Cause: The PostScript fonts are missing
Solution: Perform a full firmware update.
SE 61:04.2
Cause: PostScript unknown Paper ID
Solution: Perform a full firmware update.
SE 61:08
Cause: The paper type specified in the file is incorrect and the printer cannot process the job
Solution: Try the following.
●
Turn off the printer using the switch at the rear, and disconnect the power cord. Reconnect the
power cord and turn on the printer.
●
Change the paper type and resend the file to the printer.
SE 61:08.1
Cause: The file cannot be printed because it is password-protected
Solution: Resend the file without password protection.
SE 61:08.2
Cause: The file contains format errors or incorrect settings and the printer cannot process the job
Solution: Try the following.
●
Ensure that the file format sent is supported by the printer.
●
Turn off the printer using the switch at the rear, and disconnect the power cord. Reconnect the
power cord and turn on the printer.
●
Resend the file to the printer using the Embedded Web Server.
70 Chapter 3 System error codes ENWW
To Next Page
Loading...