SE 61:10
Cause: A slow computer processing complex files can pause for longer than the default printer
timeout, which can be interpreted by the printer as an End Of Job, in which case some elements of the
job may be lost
Solution: Try the following:
●
Increase the I/O timeout using the printer's front panel (see 'Configure network settings' in Using
your printer).
●
Send the job from a faster computer.
●
Send the job from the Embedded Web Server.
SE 64.1:01
Cause: The printer does not recognize the USB Hard Disk Drive accessory
Solution: Try the following.
●
Turn off the printer using the switch at the rear.
●
Connect the Hard Disk Drive accessory, check that the USB cable is properly connected and turn
the printer on. If the Hard Disk Drive accessory is not available (has been lost or broken), proceed
to the next step.
●
If the problem persists, turn off the printer using the switch at the rear. Turn the printer on again
while pressing Menu, OK and Cancel simultaneously until the front panel asks Printer
configured to use External Hard Disk. Do you want to revert the printer to
Internal Hard Disk?. Confirm by pressing OK (twice). Remove the Hard Disk Drive accessory
(if connected). The printer restarts.
●
After the printer reaches the Ready state, try connecting any other USB device (known to work
properly) to the printer port where the Hard Disk Drive accessory should be connected. If a
message appears on the front panel reacting to the USB device just connected (such as Please
remove USB device or Press OK to...), press Cancel and remove the USB Device. This
means the Hard Disk Drive accessory is faulty and should be replaced. See Formatter.
●
If nothing appears on the front panel reacting to the USB device just connected, the Formatter is
faulty and should be replaced. See Formatter.
SE 71:03
Cause: Out of memory failure
ENWW
Continuable and non-continuable error codes
71
To Next Page
Loading...