Solution: Try the following.
●
Turn off the printer using the switch at the rear, and disconnect the power cord. Reconnect the
power cord and turn on the printer.
●
If the problem persists, resend the job with one or more of the following options:
◦
Decrease resolution to 300 dpi.
◦
Select Economode print mode.
◦
Select Send Job As Bitmap, to have the main processing of the print job done by the
computer rather than the printer.
SE 71:08
Cause: Insufficient display list
Solution: Resend the job with one or more of the following options: decrease resolution to 300 dpi,
select Economode print mode, select Send Job As Bitmap to have the main processing of the print
job done by the computer rather than the printer.
SE 74:01
Cause: Error uploading firmware update file
Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Resend the firmware update file to the printer.
SE 75.21:10
Cause: Total printer ink consumption reached upper limit
Solution: This is a continuable system error. The customer may continue to print normally but may
encounter print-quality issues or ink buildups in the Service Station. To avoid these problems, it’s best to
apply Preventive Maintenance Kit #2.
SE 76:03
Cause: Hard Disk Drive out of space
Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Resend the file to the printer.
●
Remove any unnecessary files from the Hard Disk Drive using the Web Server.
●
If the problem persists, perform Hard Disk Recovery (see
Hard Disk recovery on page 120).
72 Chapter 3 System error codes ENWW
To Next Page
Loading...