SE 77:04
Cause: Embedded Web Server internal software error
Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Check that the printer has the latest firmware version. If not, update the firmware to the latest
version.
SE 78.1:04
Cause: Media Settings area missing in media settings file
Solution: Resend the file.
SE 79:03
Cause: Generic firmware error
Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Check that the printer has the latest firmware version. If not, update the firmware to the latest
version.
●
If the problem persists, perform Hard Disk Recovery (see
Hard Disk recovery on page 120).
SE 79:04
Cause: Generic firmware error
Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Check that the printer has the latest firmware version. If not, update the firmware to the latest
version.
●
Try to reprint the image using different selections in the driver.
●
Disable nesting and the queue.
●
If the problem persists, perform Hard Disk Recovery (see
Hard Disk recovery on page 120).
●
For more detailed information, see
How to troubleshoot the 79:04 system error on page 28.
SE 79.2:04
Cause: Operating-system signal error
ENWW
Continuable and non-continuable error codes
73
To Next Page
Loading...