HP DesignJet T770 Series Manual

Introductory Information
Message or code Recommendation
61:01 The le format is wrong and the printer cannot process the job. Check the
graphic language setting of your printer. If you are sending PostScript from
Mac OS over a USB connection, select ASCII encoding in both the driver and
the application. Check for the latest rmware and driver releases.
62, 63, 64, 65, 67 Update your printer’s rmware.
71.04 Out of memory. To avoid this, in the HP-GL/2 and HP RTL driver select the
Advanced tab and then Send job as a bitmap.
74.1 Try the rmware update again. Do not try to use your computer while the
update is in progress. If the problem persists, contact HP Support.
79:03 Restart the printer. If the problem persists, contact HP Support.
79:04 Update your printer’s rmware.
81:01, 86:01 Please follow the instructions on the front panel. You may be asked to run a
test procedure and write down a numeric code before contacting HP Support.
94, 94.1 Restart color calibration.
4
Hewlett-Packard Company - Learning Products - Barcelona

HP DesignJet T770 Series Specifications

General

Print Technology	Thermal Inkjet
Print Resolution	Up to 2400 x 1200 optimized dpi
Line Accuracy	+/- 0.1%
Ink Types	Dye-based (color), pigment-based (black)
Connectivity	Hi-Speed USB 2.0 certified
Number of Print Cartridges	6 (cyan, magenta, yellow, gray, matte black, photo black)
Hard Disk	160 GB
Print Languages	HP-GL/2, HP-RTL
Maximum Print Width	24-in: 610 mm
Media Types	Bond and coated paper, technical paper, film, photographic paper, self-adhesive
Processor	1.2 GHz
Operating Systems Supported	Windows, Mac OS
Dimensions	1770 x 700 x 1050 mm
Power Consumption (Voltage)	100 to 240 VAC (+/- 10%), 50/60 Hz
Media Sizes Supported	24-inch models: 8.3 to 24-in wide sheets, 24-in wide rolls; 44-inch models: 8.3 to 44-in wide sheets, 44-in wide rolls