File System Check
The File System Check checks the file system on the hard disk and automatically corrects any problems that
it finds.
1. In the Diagnostics menu, select File System Check and press on this menu option.
2. The Front Panel asks you if you want to proceed with the File System Check.
3. Press OK to proceed or Back/Cancel to exit.
If you press OK, the product restarts and the File System Check is performed.
Rewinder Adjust
The Rewinder Adjust utility clears the calibration parameters associated with a Rewinder motor when it has
to be replaced.
The changes made by this utility take effect only after the product has been restarted. Therefore, you are
recommended to proceed in the following order.
1. Use the Rewinder Adjust utility to reset the calibration parameters.
a. In the Service Utilities submenu, scroll to Rewinder Adjust and press on this menu option.
b. Enter the 4-digit 2nd level access code “5494” and press OK.
c. Select the Rewinder for roll 1 or roll 2 and press OK.
d. Confirm your selection by pressing OK.
e. The product resets the calibration parameters and checks that the default values have been
correctly saved inside the NVM memory. If the check fails, a 79:04 error is generated, and the
procedure is interrupted. Otherwise, the product confirms success.
2. Turn off the product.
3. Replace the Rewinder motor.
Double Cut for Borderless Printing
This utility disables the double cut that the printer makes in order to print borderless images on photo media.
Remove non Factory Papers
This utility removes the paper profiles that were installed by the user. It does not remove any original paper
profile shipped with the printer.
Use this utility when a paper profile installed by the user could be the cause of the problem.
1. In the Service Utilities submenu, scroll and select Remove non factory papers.
2. Press OK to confirm the removal.
Secure File Erase Mode
The purpose of this Service Utility is to erase data from the printer's Hard Disk.
ENWW Service Utilities 191
To Next Page
Loading...
