Load a roll into the printer
There are two ways to load a roll. The easy loading procedure is recommended.
NOTE: To start these procedures you must have a roll loaded on the spindle.
See
Load a roll onto the spindle on page 8.
Easy loading procedure
1. Standing behind the printer, rest the spindle's black end on the left side roll
holder. Do not put the end completely into the roll holder.
2. Rest the blue end of the spindle on the right side roll holder.
3. With both hands, push the spindle into both roll holders at the same time. The
spindle snaps into place.
10 Chapter 3 Paper handling ENWW
Paper handling
To Next Page
Loading...