1. If you have already started the unload process, press on the front panel to cancel that procedure.
2. Lift the blue lever on the left. If the front panel displays a warning about the lever, ignore it.
3. Pull out the paper from the printer. Pull from wherever the paper is accessible; the back of the printer is
recommended. You may need to open the roll cover.
4. Lower the blue lever.
Manual unload procedure
Paper types that cannot be cut by the automatic cutter must be unloaded manually.
1. Open the roll cover.
2. Lift the blue lever on the left.
3. Rewind the paper by turning the spindle manually, until the paper is removed from the printer.
4. Lower the blue lever.
5. Close the roll cover.
Load a single sheet
1. Ensure that the cover of roll 1 is closed. If it is opened while a sheet is loaded, the sheet will be
immediately unloaded.
2.
At the front panel, press
then the roll 1 icon, then Load > Load sheet.
Alternatively, press
, then , then Paper > Paper load > Load sheet.
3. If a roll is already loaded, you have to wait while it is withdrawn to the standby position; it can be
printed on again without reloading as soon as the sheet paper has been unloaded.
NOTE: If at any time you open a roll cover while that roll is in the standby position, the roll will be
automatically unloaded, and you will have to reload it the next time you want to print on it.
NOTE: If the roll is uncuttable, the front panel gives instructions for unloading it manually.
4. Select your paper category and type.
TIP: If you have loaded a paper type whose name does not appear in the paper list, see The paper type
is not in the driver on page 119.
40 Chapter 5 Paper handling ENWW
To Next Page
Loading...
