Here are some recommendations to help you deal with a long queue of printing jobs.
●
If feasible, use brand-new long rolls of paper.
●
If you want to print on partly-used rolls, you can check the paper type and the remaining length in the
Embedded Web Server or in the front panel, to confirm that you have enough paper to print all your
jobs.
NOTE: Information on the remaining length is available only if you told the printer the length of the
roll when you loaded it, or if the printer read the length of the roll from the barcode printed on it.
●
Load two rolls of paper suitable for your jobs. If the printer finishes one roll, it will automatically switch
to the other.
●
If you intend to use two rolls, avoid using uncuttable paper (such as canvas) for the first roll, because
then the printer will be unable to switch to the other roll.
●
Check that you have paper wide enough to print all of your jobs. Any jobs that are too wide may be put
on hold for paper if the paper mismatch action is set to Put job on hold (see
Paper mismatch action
on page 23).
●
Check the ink levels remaining in your ink cartridges.
●
When you have submitted your print jobs, you can use the Embedded Web Server from a remote
location to monitor their status.
●
Drying time should be set to Optimal.
●
Press
, then , then Setup > Printing preferences > Paper options > Roll switching options >
Minimize roll changes or Use roll with less paper.
We recommend the following settings, depending on the paper type and what kind of prints you are making.
Table 7-1 Recommended settings for unattended printing
Print type Print mode Max Detail Drying time Paper types
Lines Normal Off Optimal Coated, Bond,
Heavyweight Coated,
Glossy
Lines and fills Normal Off Optimal Coated, Bond,
Heavyweight Coated,
Glossy
Maps Best Off Optimal Coated, Heavyweight
Coated, Glossy
Renderings,
photographs
Best Off Optimal Coated, Heavyweight
Coated, Glossy
ENWW Advanced print settings 63
To Next Page
Loading...
