2. Click the Plot icon at the top of the window.
3. The Plot window opens.
4. You can see further options by pressing the circular button in the lower right corner of the window.
NOTE: The Quality option here does not refer to the final print quality but to the quality of AutoCAD
viewport objects that are sent for printing.
5. Press the Properties button.
6. Select the Device and Document Settings tab, and press the Custom Properties button.
7. In the Paper/Quality tab, check the Show preview before printing box, and select the paper type that
you intend to use.
NOTE: If you select neither the paper source nor the paper type, the printer will not print on any
protected roll (see
Roll protection on page 62).
8. Select the print quality (your own choice between speed and quality of printing).
9. If you intend to print on roll paper, you must decide where the printer should cut the paper. Press the
Margins/Layout button and select Clip contents by margins.
10. Select the Features tab, then select the Autorotate and Crop lines options. Autorotation can help to
avoid wasting paper, and the crop lines will show you where to cut the paper after printing.
ENWW Print a project 85
To Next Page
Loading...
