3. Ensure that the correct printer is selected, then press the Properties button.
4. Select the Device and Document Settings tab, and press the Custom Properties button.
5. In the Paper/Quality tab, check the Show preview before printing box, and select the paper type that
you intend to use.
NOTE: If you select neither the paper source nor the paper type, the printer will not print on any
protected roll (see
Roll protection on page 62).
6. Select the print quality (your own choice between speed and quality of printing).
7. If you intend to print on roll paper, you must decide where the printer should cut the paper. Press the
Margins/Layout button and select Clip contents by margins.
8. If you are using photo or glossy paper, you can select Borderless printing.
9. Select the Features tab, then select the Autorotate and Crop lines options. Autorotation can help to
avoid wasting paper, and the crop lines will show you where to cut the paper after printing.
10. Press the OK button and save your configuration changes to a PC3 file.
88 Chapter 11 Practical printing examples ENWW
To Next Page
Loading...
