Right Connector Cover 285
Removal & Installation
Right Connector Cover
Removal
1. For the 42-inch model, remove the Rear Door
⇒
See
page 281
2. For the 60-inch model, and optionally the 42-inch
model, disconnect the TUR connector.
3. For the 60-inch model, and optionally the 42-inch
model, unroute the TUR cable from the Right Connector
Cover.
4. Remove two T-20 screws (Type B) from the Right
Connector Cover.
WARNING!: Switch off the printer and remove the power cable.
To Next Page
Loading...