Need help?Do you have a question about the HP Z6100 - DesignJet Color Inkjet Printer and is the answer not in the manual?
General| Maximum Print Resolution | 2400 x 1200 DPI |
|---|---|
| Number of Ink Cartridges | 8 |
| Internal memory | 512 MB |
| Connectivity | USB 2.0, Ethernet |
| Print speed (draft quality) | Up to 129 ft²/hr (12 m²/hr) on coated media |
| Print margins (roll) | 5 x 5 x 5 x 5 mm |
| Print margins (sheet) | 0.2" (5 mm) top and bottom, 0.4" (10 mm) leading edge |
| Media Types | Bond, coated paper |
| Ink Colors | Cyan, Magenta, Yellow, Light Cyan, Light Magenta |
| Operating Systems Supported | Windows, Mac OS |
Use for ink smears on media or print quality issues.
Clean sensor window when cleaning platen or for print quality issues.
Use for 'Possible media jam' errors or when margins shift.
Use for printhead connection problems.
Use for printhead carriage lubrication if media jam errors occur.
Use if platens rollers squeak.
Use when prompted by the front panel to change the ink absorber.
Clean the sensor window using a lint-free cloth and isopropyl alcohol.
Wipe the encoder strip carefully to remove ink residue with a damp cloth.
Follow steps to insert a new sponge into the printhead carriage.
Clean the printheads and their connections following the illustrated steps.
Remove the used sponge from the printhead carriage following the steps.
Apply oil to the printhead carriage pads and slider rod.
Apply oil to the holes on the sides of the rubber wheels if noise is heard.
Remove and replace ink absorber following panel prompts and local regulations.
Contains copyright, disclaimers, and warranty information.
To Next Page
