HP Z6100 - DesignJet Color Inkjet Printer Assembly Instructions

1m
3.5ft
1m
3.5ft
3m
10ft
HP Designjet Z6100
60-in Printer
©2007 Hewlett-Packard Company.
Inkjet Commercial Division
Avenida Graells 501
08174
Sant Cugat del Vallès,
Barcelona
Spain
All rights reserved.
Assembly instructions
Please read these instructions carefully
Time required for assembly of the
printer is approximately 160 minutes.
4 people are required to perform
certain tasks.
These assembly instructions explain how to assemble the printer.
Notice that the icons used in this document are also located on the printer packaging.
The icons help you locate the parts needed at each stage of the assembly.
Because spare screws are supplied, some screws will remain unused after assembly of
the printer.
1. Printer engine.
2. Stand.
3. Take-up Reel.
5. Supplies.
Used to rotate the printer.
EN
5
2
3
4
1
x8
x8
Page 1
4. Spare box.
Used to rotate the printer.
The space required for assembly is
3m (10 feet) in front and
1m (3.5 feet) at the sides and rear.
2.5h

HP Z6100 - DesignJet Color Inkjet Printer Specifications

General

Maximum Print Resolution	2400 x 1200 DPI
Number of Ink Cartridges	8
Internal memory	512 MB
Connectivity	USB 2.0, Ethernet
Print speed (draft quality)	Up to 129 ft²/hr (12 m²/hr) on coated media
Print margins (roll)	5 x 5 x 5 x 5 mm
Print margins (sheet)	0.2" (5 mm) top and bottom, 0.4" (10 mm) leading edge
Media Types	Bond, coated paper
Ink Colors	Cyan, Magenta, Yellow, Light Cyan, Light Magenta
Operating Systems Supported	Windows, Mac OS