366 Chapter 8 Removal & Installation
Removal & Installation
Installation
The following illustration shows a cross-section of the Vacuum Beam with the OMAS Cable correctly routed
to avoid interference to the Media Sensor.
1. Before you can start to install the OMAS Cable you
must first identify which end connects to which
component. The end of the cable that has the most
perpendicular and diagonal folds is the end that
connects to the OMAS with the blue reinforcing on the
top. The other end must be connected to the OMAS
Controller Card with the blue reinforcing on the bottom.
1. Carefully slide the Ferrite Core and its associated
attachment plate out of the vacuum beam.
CAUTION: It is critical that the OMAS Cable is correctly positioned in the Vacuum Beam so that it does
not cause physical interference to the Media Sensor.
To Next Page
Loading...