378 Chapter 8 Removal & Installation
Removal & Installation
5. Disconnect ALL cables connected to the Hard Disk
Drive.
6. Remove one T-10 screw (Type I) from the HDD Holder.
7. Slide the Hard Disk Drive upwards and remove from
the Printer.
• Printhead Alignment
.
• Paper Advance Calibration
.
• Color Calibration
.
• Carriage PCA Setup
⇒
Chapter 4.
NOTE: It is not necessary to remove the
screws securing the HDD inside the metal
casing.
NOTE: After installing the NEW HDD, make
sure you perform the following User
Calibrations:
NOTE: After installing the NEW HDD, make
sure you perform the following Service Utility:
NOTE: You MUST NEVER replace both the Hard Disk Drive and the Ink Supply Tubes and Trailing
Cable at the same time. If both parts need to replaced, you MUST first replace one part and then power
ON the Printer until it completely initializes. Then you can power OFF the Printer and replace the other
part.
To Next Page
Loading...