HP Designjet Z6100 Printer series

384 Chapter 8 Removal & Installation
Removal & Installation
PrintMech PCA
Removal
1. Remove:
• For the 42-inch model, the Left Connector Cover
⇒ See page 287.
• For the 60-inch model, the Electronics Module
Extension⇒ See page 288.
2. Remove three T-15 screws (Type A) that secure the PSU
cover.
3. Remove the PSU Cover from the Printer.
4. Slide the PrintMech Cover out of the Printer.
WARNING!: Switch off the printer and remove the power cable.
1
2
1
2