Preventive Maintenance 457
Preventive Maintenance
10. Switch Off the Printer from the back.
11. Open the Printer Window and move the Carriage Assembly further to the left.
12. Clean the part of the Encoder Strip inside the Service Station.
13. Close the Printer Window and turn On the printer.
14 . From the Front Panel, select the Setup icon and then select Resets>Reset Encoder Cleaning
Clean the paper-advance sensor window
The paper advance sensor is the very small rectangular window (less than 1 square centimeter in size and
shown in the following graphic) near the sixth platen roller from the right.
To Next Page
Loading...