Printhead replacement must be performed after the printer has been turned on at the
hard power switch.
1.
At the printer's front panel, select the
icon, and then select Replace
printheads.
2.
The printer moves the carriage into the correct position.
CAUTION: If the carriage remains in the removal position for more
than 3 minutes without inserting or removing any printheads, it will
attempt to return back to its home position to the right.
3.
When the carriage has stopped moving, the front panel prompts you to open
the printer window.
4.
Locate the carriage on the right side of the printer.
Pull up and release the latch on top of the carriage.
30 Chapter 3 Handle the ink system
Handle the ink
To Next Page
Loading...
