NOTE: If you experience a paper jam, HP recommends that you reinsert
the printheads and align the printheads.
TIP: Use the same paper you intend to print on to align the printheads.
Photo paper is recommended for the best results. Plain; bond; and thin,
coated papers are acceptable, but provide marginal results.
WARNING! Colored papers, glossy canvas, and transparent materials
such as translucent bond, clear film, tracing paper, and vellum are not
suitable for aligning the printheads. However, if you must perform printhead
alignment with a material that is not supported, make sure you use a material
with the same thickness as the material you are going to use for printing.
Reinsert printheads procedure
1.
If the printhead alignment process is running and the wrong paper is loaded,
press the Cancel button on the front panel.
CAUTION: Do not print if the printhead alignment process has been
canceled.
2.
Load the paper you want to use. Photo paper is recommended for the best
results.
WARNING! Colored papers, glossy canvas, and transparent
materials such as translucent bond, clear film, tracing paper, and vellum
are not suitable for aligning the printheads. However, if you must
perform printhead alignment with a material that is not supported, make
sure you use a material with the same thickness as the material you are
going to use for printing.
Align the printheads
75
Troubleshoot ink
To Next Page
Loading...
