set paneling and tiling options
djcc-51.htm[28/10/2014 15:47:33]
If the Tiling option is selected, cut lines and glue marks (D) will be
printed, both for horizontal connection (as illustrated above) and for
vertical connection.
Bring your panels together by overlapping the edges with each
rightmost panel (B) on top of the panel on its left (A). The second
panel in a row overlaps the first panel; the third overlaps the second
and so on as illustrated below. Vertical connection (tiling only) is
performed with the first row at the lowest level and then each
following row overlaps the bottom edges of the tiles in the row
before it.
printing instructions legal information
© 2002-2014 Hewlett-Packard Company
To Next Page
Loading...
