Status Description
The Wireless light is blinking, and the Wireless icon and
Wireless Attention icon are on.
There is no wireless signal.
—
Make sure your wireless router or access point is
powered on.
—
Move the printer closer to the wireless router.
The Wireless light is blinking, the Wireless icon is on, and the
Wireless Attention icon is blinking.
One of the following might have occurred.
—
The printer has a problem connecting to the wireless
network.
—
An error occurs or an overlap session is detected when
using WPS.
Press the Wireless button ( ) and the Information button
( ) together to run the wireless test, and then review the
test report for information on how to solve the problem.
Wi-Fi Direct light and icon
●
Status Description
The Wi-Fi Direct light and icon are on. Wi-Fi Direct is turned on and ready to use.
To learn how to connect to your printer using Wi-Fi Direct, see
Connect wirelessly to the printer without a router
on page 59.
The Wi-Fi Direct light and icon are o. Wi-Fi Direct is o.
To turn on Wi-Fi Direct, press the Wi-Fi Direct button ( ).
The Wi-Fi Direct light is blinking. The printer is connecting to a mobile device in the Wi-Fi
Protected Setup (WPS) push mode. Press the Wi-Fi Direct
button ( ) to nish connecting.
The Wi-Fi Direct light blinks fast for three seconds, and then
stays on.
The printer already has the maximum number of Wi-Fi Direct
connection and another device is trying to connect to the
printer with Wi-Fi Direct.
The Wi-Fi Direct light blinks fast for three seconds, and then
turns o.
Wi-Fi Direct is disabled. For more information, contact the
person who sets up the printer.
Web Services light
●
8 Chapter 2 Get started ENWW
To Next Page
Loading...