WINDOWS 95 OR WINDOWS NT 4.0
If a message comes up before or during installation that
says, “New Hardware Found,” choose “Do not install a driver
(Windows will not prompt you again)” and click OK.
1 Insert the CD-ROM or disk 1 into your computer’s drive.
2 Click Start on the task bar, and then click Run.
3 Type the letter of the computer’s drive (usually D:\, B:\, or
A:\), type SETUP, and click OK.
4 Follow the directions on the computer screen.
If you’re not sure how to answer a question that appears
on the screen, just press ENTER to accept the most com-
mon settings.
5 When the Installation is done, take the disk out of your
computer, and restart Windows.
Store your disks in a safe, cool, dry place.
SetupGuide Page 11 Friday, July 25, 1997 1:13 PM
To Next Page
Loading...