Removal and replacement procedures 31
Figure 3 Removing the top middle cover
To reinstall the top middle cover:
1. Align the top middle cover to the chassis.
2. Fasten the four screws (one on each side of the chassis and two on the top middle cover) to
securing the top middle cover to the chassis.
Figure 4 Reinstalling the Top Middle Cover
Drives
The server supports 9 to 12 drive bays --- 8 drive bays for 3.5-inch hard disk drives and 1 drive bay
for optical disc drive; or 12 drive bays for 3.5-inch hard disk drives.
Cable Management
Always follow good cable management practices when working inside the server.
To Next Page
Loading...
