SATA Channel 1 Master
SATA Channel 2 Master
For each, allows you to:
●
run HDD self-test for selected channel:
●
SMART Status Check
●
HDD Short Self-Test
●
HDD Extended Self-Test
●
set extended IDE drive on selected channel to:
●
None
●
Auto
●
set access mode on selected channel to:
●
Large
●
Auto
●
view:
●
Firmware Version
●
Capacity
●
Cylinder
●
Head
●
Precomp
●
Landing Zone
●
Sector
Floppy Controller Disables/enables the floppy disk controller.
Drive A Allows you to set Drive A to:
●
None
●
1.44M, 3.5 in.
Halt On Allows you to set POST error behavior to:
●
All Errors
●
No Errors
●
All but Keyboard
●
All but Diskette
●
All but Diskette/Keyboard
POST Delay Allows you to set a POST delay to:
●
0 seconds
●
5 seconds
●
10 seconds
Table 3 Computer Setup—Standard CMOS Features (continued)
ENWW Computer Setup (F10) Utilities 5
To Next Page
Loading...
