HP E1440A - Page 105

- "SRE
Syntax
Definition
Related Commands
Example
Service request enable register.
*SRE <value>
0 _< value < 255
The service request enable command sets bits in the service request
enable register
which enable the corresponding status byte register
bits.
The register is cleared:
At power-on
rn By sending a value of zero.
The register is not changed
by the *RST and *CLS commands.
BITS MNEMONICS BIT VALUE
The Service Request Enable Register
7 Operational status summary bit
6 RQS/MSS
5 ESB
4 M AV
3 Not used
2 Not used
1 Not used
0 Not used
OUTPUT 7091 1 ; "*SRE 48"
Command Reference 5-43
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com