EasyManua.ls Logo

HP E1440A - Page 181

HP E1440A
192 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
-222,"Data out of range;
DC
Offset is out of range"
Triggered
by:
V0LT:OFFS command. Requested
DC
offset voltage
is out of absolute bounds.
-222,"Data out of range; Dwell time of
LOG
interval too low (<O.ls)"
Triggered by: FREQ:MODE command. Dwell time for one of the
LOG intervals is less than 0.1 sec.
-222,"Data out of range; Frequency is too low"
Triggered by: FREQ command. FIX frequency is
<
0.
-222,"Data out of range; Frequency too high for output function"
Triggered by: FUNC or FREQ command. FREQ is too high for the
output function.
-222,"Data out of range; Marker index is out range"
Triggered by: MARK:STAT and MARK:FREQ command. Attempt
to set marker index outside the range
1
..
9.
-222,"Data out of range; Phase offset is out of range (-720
..
720 deg)"
Triggered by: PHAS command. Attempt to set phase outside the
range -720
..
720 degree.
-222,"Data out of range; *SAV/*RCL register number out of range (0
..
9)''
Triggered by: *SAV or "RCL command. Command argument
(register number) is outside the range 0
..
9.
-222,"Data out of range; Start frequency in list is too high or negative"
Triggered by: FREQ:MODE command. One of the sequenced start
frequencies in the list, is too high or negative.
-222,"Data out of range; Start frequency is too low"
Triggered by: FREQ:MODE command. FREQ:STAR value is too
low (negative).
-222,"Data out of range; Start frequency too high for output function"
Triggered
by:
FREQMODE
command.
FREQSTAR
value
is
too
high for the output function.
-222,"Data out of range; Stop frequency in list is too high or negative"
Triggered by: FREQ:MODE command. One of the sequenced stop
frequencies in the list, is too high or negative.
-222,"Data out of range; Stop frequency is too low"
Triggered by: FREQ:MODE command. FREQ:STOP value is too
low (negative).
-222,"Data out of range; Stop frequency too high for output function"
Triggered by: FREQ:MODE command. FREQ:STOP value is too
high for the output function.
Error
Messages
E-5
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Table of Contents

Related product manuals