HP E1440A - Page 42

900 !
910
! The lists are in the box -- base setting
920 !
930 OUTPUT E1440;":FUNC SIN; :VOLT 5 V; :OUTP ON"
940 !
950 !
set instrument in list mode and initiate one sweep cycle
960 !
970 OUTPUT EI440;":FREQ:MODE LIST; :INIT1'
980 !
990 ! issue *OPC? command and read response.
1000
! the response will not be sent by the El440 until the currently
1010 ! running sweep stops.
1020
! note that this may cause an I/O timeout on the controller if
1030 ! timeout is set too short for the HP-IB interface.
1040 !
1050 OUTPUT El440 ; "*OPC?"
1060 ENTER
E1440;0pc,resp$
1070 !
1080 ! ready, print the message and end
1090 !
1100 PRINT "List sweep finished"
1110 !
1120 END
3-10 Using the HP E1440A
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com