[:SOURce]:SWEep
The :SWEep command subsystem controls the generation of a sweep
signal output
Subsystem Syntax
[:SOURce]
:SWEep
:TIME <numeric value>
:RETRace <numeric value>
:AUTO <boolean>
I
ONCE
:DIRection UP
1
DOWN
:SWEep:TIME
This command sets the duration of the sweep. Using this command
does not turn sweeping on, it merely specifies duration.
:SWEep:TIME:RETRace
This command is similar to :TIME and sets the duration of the
sweep retrace time.
-
Comments
:SWE:TIME:RETRace;
Defines the retrace time for SWEep and
LIST
:SWEep:TIME:RETRace:AUTO
has the following parameters:
ON:
RETRace adopts the same value as TIME and follows any
change in the value of TIME.
OFF:
RETRace is independent from TIME. Setting RETRace
via the SWE:RETRace <num> command, switches AUTO to
OFF.
ONCE
Is equivalent to :AUTO:ON;:AUTO:OFF, then RETRace
follows TIME and AUTO is OFF.
5-26
Command Reference
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
