Select To do this
Built-In Device Options ● Enable/disable the wireless button state (enabled by
default).
●
Enable/disable embedded WWAN device radio (select
models only; enabled by default).
● Enable/disable embedded WLAN device radio (select
models only; enabled by default).
● Enable/disable the embedded Bluetooth device radio
(enabled by default).
●
Enable/disable the network interface controller (enabled
by default).
●
Enable/disable LAN/WLAN switching (disabled by
default).
●
Set the wake on LAN state. Options include the
following:
◦
Disabled
◦
Boot to Network
◦ Follow Boot Order
●
Enable/disable the ambient light sensor.
●
Enable/disable the fingerprint device (enabled by
default).
●
Enable/disable the integrated camera (enabled by
default).
●
Enable/disable the power monitor circuit (enabled by
default).
●
Enable/disable the audio device (enabled by default).
● Enable/disable a modem device (enabled by default).
●
Enable/disable the microphone (enabled by default).
●
Enable/disable the internal speakers (enabled by
default).
Port Options NOTE: All port options are enabled by default.
●
Enable/disable the flash media reader.
●
Enable/disable the USB port.
CAUTION: Disabling the USB port also disables
MultiBay devices and ExpressCard devices on the
advanced port replicator.
●
Enable/disable the 1394 port.
● Enable/disable the ExpressCard slot.
●
Enable/disable the Smart card slot.
●
Enable/disable the eSATA port.
140 Chapter 14 Computer Setup
Downloaded from LpManual.com Manuals
To Next Page
Loading...
