10. If it is necessary to remove the ambient light sensor board, remove the foil shield from on top of the
board (1), lift upward to disengage the board from the adhesive on the display enclosure (2), disconnect
the cable from the board (3), and then remove the board from the display (4).
The ambient light sensor board is available as spare part number L60629-001.
11. If it is necessary to remove the display panel from the enclosure, remove the four Phillips M2.0 × 2.0
screws that secure the panel to the display enclosure.
12. Rotate the display panel over onto the keyboard (1).
Component replacement procedures 69
To Next Page
Loading...
