HP EliteBook 8440W - Page 114

5–18 Maintenance and Service Guide
Computer Setup
Select To do this
System Configuration menu (continued)
Device Configurations (continued) ■ Enable/disable Data Execution Prevention (select models
only). When enabled, the processor can disable some virus
code execution, which helps to improve computer security
(disabled by default).
■ Set the SATA (Serial Advanced Technology Attachment)
device mode. The following options are available:
❐ AHCI (Advanced Host Controller Interface)
❐ IDE (Integrated Drive Electronics)
❐ RAID (select models only)
✎
Availability of these options varies by computer model.
■ Enable/disable secondary battery fast charge (enabled by
default).
■ Enable/disable HP QuickLook (enabled by default).
■ Enable/disable Preboot Authentication on HP QuickLook
Boot (enabled by default).
■ Enable/disable HP QuickWeb (enabled by default).
■ Enable/disable HP QuickWeb Write Protect (disabled by
default).
❐ Enable/disable Virtualization Technology (select models
only; disabled by default).
■ Enable/disable TXT (Intel Trusted Execution Technology)
(select models only; disabled by default).
■ Enable/disable Multi Core CPU (enabled by default).
■ Enable/disable Intel HT Technology (enabled by default).
■ Enable/disable Wake on USB (enabled by default).
■ Enable/disable Num lock state at boot (disabled by default).
Built-In Device Options ■ Enable/disable the wireless button state (enabled by
default).
■ Enable/disable embedded WLAN device radio (select
models only; enabled by default).
■ Enable/disable the embedded Bluetooth® device radio
(enabled by default).
■ Enable/disable the Network Interface Controller (LAN)
(enabled by default).
■ Enable/disable LAN/WLAN switching (disabled by default).
■ Set the wake on LAN state. Options include the following:
❐ Disabled
❐ Boot to Network
❐ Follow Boot Order
■ Enable/disable the Ambient Light Sensor.
■ Enable/disable the Notebook Upgrade Bay device (enabled
by default).
■ Enable/disable the fingerprint device (enabled by default).
■ Enable/disable the integrated camera (enabled by default).
■ Enable/disable the Power Monitor Circuit (enabled by
default).
■ Enable/disable the audio device (enabled by default).
■ Enable/disable a modem device (enabled by default).
(Continued)