The rubber-screw cover locations are shown in the following image.
NOTE: If installing new rubber screw covers, carefully inspect for adhesive tape liner inside the cap and
remove if present.
To properly insert the rubber covers, be sure to orient the covers in the correct direction:
1. Place the lower edge into the recess (1), followed by the higher edge (2).
2. Use a small plastic rod or the soft part of your nger (not a ngernail) to ensure compaction into the
recess.
3. Visually inspect all rubber caps to be sure that they installed in the correct locations. Run a nger over
the tops of the rubber caps to ensure they are properly seated.
Component replacement procedures 37
To Next Page
Loading...
